HI-FI DX BASS CIRCUIT

1. The circuit that designed is a passive one but you can make it an active one by adding a pre amp at the output.
2. The first stage acts as a main tone stage. It balances the bass and the treble. The 0.01 cap is for high frequency while the 0.22uF cap is for low frequency.
3.  The second stage is for sound compression.
4.  he caps works the same as at the first stage only that they are there to start the sound compression that is received from the input stage.
5.  The 2.2k resistor delays the sound thereby multiplying the compression.
6.  The 10k variable resistor is there used to tune the compression depending on the frequency of the speaker. If you are using 4 to 6 inches hi-fi speakers, I advise you to keep the 10k variable resistor at 0 ohm.
7. The circuit is not copyrighted and you can change it to suit your requirement. All I ask is to be posting the updates of the circuit design on the site.
   
   
   
   
   
   
   
   
   NOTES:
   

   • Assemble the circuit on a good quality PCB.
   • This circuit does not require a power supply.
   • POT R6 is for volume control.
   • Switch S1 can be a slide switch and it is the DX Bass switch.