BATTERY ELIMINATOR CIRCUITS

1. Here is the circuit diagram of a battery eliminator circuit that can be used as a replacement for 9V PP3 batteries.
2. The circuit given here can be used to power any device that operates from a 9V battery.
3. The transformer T1 steps down the mains voltage and bridge D1 performs the job of rectification.
4. Capacitor C1 is a filter. IC LM317T is the regulator here.
5.  The value of R1, R2 and R3 are so selected that the output voltage of IC1 will be steady 9 volts.
   

      NOTES:

• Assemble the circuit on a good quality PCB.
• Transformer T1 can be a 230V primary, 9V secondary, 1.5A step down transformer.
• If 1A Bridge is not available, then make one using four 1N 4007 diodes.
• Do not connect loads that consume more than 1.5A to this circuit.
• A heat sink is recommended for IC1.